Saving Work; Save As - IFM Electronic ecomot mobile R 360 Serie Starterset-Handbuch

Saving work

Figure 27
Figure 31
Relay When the relay has been set (if applicable), the preparations are completed.
Now the actual programming can start.
5.3. Saving work
Under this hopefully interesting headline we will describe briefly how already
created programs, modules, networks, etc. can be transferred from one project
to another. As usual there are several ways to reach the goal. Not all of them
can be shown here; we have to refer to the programming manual. Here we only
want to discuss some of the most frequently used methods.

'Save as...'

This is the easiest and probably best known way. The following procedure
makes sense to program an R360 controller, for example. It is relatively
complex to always integrate the hardware configuration etc. for each new
project if always the same hardware version, e.g. CR0020, is used. Then it is
worthwhile to create an empty project as master in which all settings have
already been made. With 'Save as...' you will get a project in which you can
work right away, without any other preparation.
5-10