IFM Electronic ecomot mobile R 360 Serie Starterset-Handbuch Seite 206

Online test
If other error messages are displayed during log-in, it may help to increase the
baud rate. The advantage is that the program is loaded faster. It has to be noted
that it is not sufficient to increase the baud rate on the PC. The baud rate in the
controller must be adapted to these values. To do so, the downloader has to be
used, see Figure 87,
This setting procedure may seem to be somewhat complicated. However, it only
has to be followed once at the beginning.
Let us assume now that communication runs correctly.
After log-in you will get the message to download the program.
Figure 97: Message Download Program
Compilation is only started when the program has been changed. As you have
already started the Login function before, the program file for the controller is
already there and does not need to be generated again.
If no program had been loaded into the controller before, you will receive a
message that is slightly different from Figure 97. If, however, there is already a
program in the memory of the controller, it will be overwritten by the new one
and thus it is lost if the source program is no longer available.
Before overwriting the loaded program you can, if required, save it with the
independent downloader program (
the program file of the controller, the source program is not saved in the
controller. The program file has been saved, but cannot be edited.
If you are not sure if a source file is available, a saving process should be
carried out. Otherwise the program in the controller will be overwritten and
cannot be restored without the source file.
The message can now be acknowledged with
When the program has been loaded in the controller, program processing has
Start program
to be started. The line at the bottom, the status line, reads (after starting):
Figure 98: Status line
When the program runs, it can be tested as before.
3-40
.
page 3-35). You can, of course, only save
.