Installation
Figure 9: Project Options 1
2.4.
Settings
New project
Before starting with the programming of the controller you would normally have
to make some additional settings. This has to be done for a configuration only
once at the beginning, compare page 2-19.
In the starter set all required settings have already been made. The following
descriptions are only for information if you work with it.
These settings are part of each project and they are saved with it. This way you
can easily work on projects for various hardware configurations with the same
user interface. To show how the settings are made we open a new project via
'File' 'new' or
a new project.
Target
A window to create the target system will open.
Figure 10: Target System Settings
R
2-7