IFM Electronic ecomot mobile R 360 Serie Starterset-Handbuch Seite 148

Software setup
Here we are dealing with CoDeSys 2.3. This is the software for programming
the current hardware. Therefore the programming examples below were
created using this version.
Figure 5: Version
The version you use depends for example on your hardware version, on the
version of its operating systems, etc. If you use different versions it may
become necessary to also install different software versions. You can, of
course, install this and other programs subsequently, for example if you want to
work with a PDM or with CAN modules. You may also want to install the
documentation on your PC. To be able to see or print the documentation here
or on CD you need Acrobat Reader. These installations will not be described in
this training manual.
The software is installed by clicking on Setup. The individual steps will not be
described here.
We recommend to adopt the default settings, e.g. the directory name, paths
etc. This will save unnecessary work. This will also make it easier to
understand the following examples.
2-2