Waeco magic control Typ MTPM-200 Montage- Und Bedienungsanleitung Seite 52

97-03 allMS RV_MTPM-200.qxm
6. Once you have completed spare wheel teaching, the tyre symbol for the front left
tyre starts to flash. "LN1" is shown continuously on the display until magic control
has stored the tyre sensor correctly. You receive an acoustic signal for 1 second as
confirmation, and the tyre symbol for the front left tyre is shown continuously. Once
magic control has correctly detected the tyre sensor, it switches automatically to the
next teaching mode.
7. Once magic control has completed front left tyre teaching, the tyre symbol for the
front right tyre starts to flash. "LN2" is shown continuously on the display until
magic control has correctly stored the tyre sensor. You receive an acoustic signal for
1 second as confirmation, and the tyre symbol for the front right tyre is shown
continuously. Once magic control has correctly detected the tyre sensor, it switches
automatically to the next teaching mode.
8. Once magic control has completed front right tyre teaching, the tyre symbol for the
rear right tyre starts to flash. "LN3" is continuously shown on the display until magic
control has correctly stored the tyre sensor. You receive an acoustic signal for
1 second as confirmation, and the tyre symbol for the rear right tyre is shown
continuously. Once magic control has correctly detected the tyre sensor, it switches
automatically to the next teaching mode.
9. Once magic control has completed rear right tyre teaching, the tyre symbol for the
rear left tyre starts to flash. "LN4" is continuously shown on the display until magic
control has correctly stored the tyre sensor. You receive an acoustic signal for
1 second as confirmation, and the tyre symbol for the rear left tyre is shown
continuously. Once magic control has correctly detected the tyre sensor, it
automatically closes the teaching mode and changes to regular mode. magic
control displays the momentary pressure and momentary temperature for each tyre.
Should magic control re-start the teaching procedure from the beginning, it has been
unable to detect the wheel sensors definitively. Please pay attention to the following
pointers.
Teaching with initial installation
Change the position of the antennas in the wheel well, so that the antennas are screened
from the opposing tyre by metallic components, and re-start the teaching procedure.
Re-teaching wheel sensors
Change the wheel sensor position to the antennas by moving the vehicle a little to or fro.
Re-start the teaching procedure to ensure that the new pressure value is correctly stored.
The teaching procedure must be completed in one pass, since magic control, under cer-
tain circumstances, may not store the changed tyre pressure and use the former tyre
pressure as a reference figure.
15.07.2003 16:49 Uhr
Wheel sensor teaching
52
Seite 52