Waeco magic control Typ MTPM-200 Montage- Und Bedienungsanleitung Seite 46

97-03 allMS RV_MTPM-200.qxm
Once all three alarm cycles have been gone through, the third alarm cycle is constantly
repeated until the correct pressure is restored.
During each alarm cycle, the current pressure of the tyre concerned is shown on the
display.
Rapid pressure loss is not shown for the spare tyre.
Please note! Should the pressure value stabilise during the three alarm phases,
the next alarm phase is no longer executed.
Changing a defective tyre for the spare wheel
During one of the described alarms, the defective tyre can be changed for the spare
wheel and the alarm thus cancelled, and the position of the sensors changed without the
complete teaching procedure having to be carried out.
1. With the ignition switched on, depress the Check key for 5 seconds. As confirmation,
you will receive a high-pitched acoustic signal for 1 second.
2. The symbols for the spare wheel and the tyre that triggered the alarm flash.
3. Depress the Check key again to confirm the tyre change.
This procedure can also be used, if the spare wheel is not equipped with a pressure
sensor.
Position
see B 1
see B 2
see B 3
see B 4
see B 5
see B 6
not shown
15.07.2003
How it works
in case of alarm
Scope of delivery
Number Description
1 Control unit
1 Display
4 Wheel sensors
2 4 m long antennas
2 6 m long antennas
1 Clip with attachment screws for the display
Installation material
40 Wire binders 2,6 x 100 mm
5 Wire binders 5 x 430 mm
1 Double-sided adhesive tape for the display
1 Double-sided adhesive tape for control unit
16:49 Uhr Seite 46
46
Art. No.
MTPM-RX
MTPM-LCD
MTPM-TX
MTPM-AT4
MTPM-AT6
MTPM-MK