Waeco magic control Typ MTPM-200 Montage- Und Bedienungsanleitung Seite 50

97-03 allMS RV_MTPM-200.qxm
Warning! Never use jacks when alone! Many accidents are caused by vehicles
sliding off jacks. Before working under the vehicle, additionally secure it with
chock-type supports.
The antennas must be allocated to the wheels as in the connecting plan (see J), so that
magic control can show the correct position of the tyres on the LCD display
Yellow (P1)
Black (P2)
Red (P3)
White (P4)
(see K)
Always start with laying the antennas to the wheels. The ends of the antenna wires (see
G H
, ) must be attached in the wheel well, so that there are no screening components
between the antenna (see
between the sensor and antenna is attained with horizontal antenna installation in the
area of the wheel well. Where possible, the antennas should be screened by metallic
components from the opposing wheel.
Lay the antenna (see
wire binders provided (see
H
) do not come into contact with rotating components and do not directly lie in the
emission range of hot components (see K 1.3).
Once you have laid the antennas in the engine bay, pull them (see
vehicle through a suitable opening (see K 2.1, K 2.2).
To ensure the opening is again waterproof, adhere the antennas (see
sulating tape in the area of the opening (see K 2.3, K 2.4).
Insert the antennas (see
Secure the antennas (see
opening (see F and K 2.5).
Having secured the antennas, seal the opening with a suitable sealing agent (see K 2.6).
.
15.07.2003 16:49 Uhr
Antenna installation
rear left
rear right
front right
front left
G H
, ) and the sensor (see K 1.4). Best possible transmission
G , H ) along the brake line and attach them (see
F , K 1.1, K 1.2). Take care to ensure that the antennas (
G , H ) into the control unit (
G , H ) against slipping with two wire binders in the area of the
50
Seite 50
G , H
G H
, ) ) inside the
G H
, ) ) with in-
B ) as per colour coding (see K 2).
) ) with the
G ,