Scheppach HMS1070 Original Bedienungsanleitung Seite 28

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new device brings you much enjoy-
ment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no
liability for damage to the device or caused by the
device arising from:
• Improper handling
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before
assembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the de-
vice, for avoiding danger, for minimising repair costs
and downtimes, and for increasing the reliability and
extending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must
be read and carefully observed by all operating per-
sonnel before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your coun-
try, the generally recognised technical rules relating
to the operation of such machines must also be ob-
served.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
28 | GB
2. Device description (fig. 1-19)
1. On/off switch
2. Overload switch
3. Plunger
4. Chip extraction
5. Parallel stop
6. M8 star grip nut
7. Planing blade cover
8. M6 star grip nut
9. Clamping lever
10. Crank handle
11. Adjusting screw
12. Feed table
13. Planing blade cover, compl.
14. Allen key
15. Ribbed belt
16. Push stick
17. Allen screw
18. Allen screw
19. Spindle
20. Threaded spindle
21. Planing table
22. Clamping lever
23. Clamping screw
24. Planer blade
25. Anti-kickback claws
26. Take-off table
27. Cutter bar
28. Tailstock holder
29. Mains cable
30. Cable holder
31. Set screw
32. Fixing screw
33. Eccentric vibration unit
A. Scale (infeed)
B. Scale (parallel stop)
C. Scale (thicknesser)
3. Scope of delivery (Fig. 1a/b)
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, keep the packaging until the expiry of
the warranty period.
•
www.scheppach.com