Lighting - Prophete REX BIKE Bedienungsanleitung

LIGHTING

• Always switch on the lighting in bad visibility conditions! Consider that not only you will
see better when the lighting is on, but that other road users will be able to see you bet-
ter as well. Danger of accident!
• The rechargeable battery must be used in bad visibility, in twilight and darkness.
DANGER
Check that the battery is sufficiently charged. Danger of accident!
• Check on every ride with the lighting switched on that the light beam is set correctly. It
must in no case be too high, since you may then blind other road users. Danger of ac-
cident!
• All lighting on electrical bicycles must be applied with the ABG test sign (~K) for ap-
proved types in Germany and correspond to the StVZO. Unapproved lighting may be
too weak in its performance or may not work reliably.
Danger of accident!
The headlight and tail light are supplied with power by the rechargeable battery. When the
lighting is switched on, this will increase safety since you can also be seen when standing. If
the drive system switches off because the battery is discharged, you will still be able to use
the lighting for at least 2 hours.
SWITCHING THE LIGHTING ON/OFF
Switch the lighting on or off by pushing the button
(fig. AD) for about 2-3 seconds.
You may also switch off the lighting by switching off
the drive system.
Systems with the EasyControl display automatically
switch the light on or off. And it can also be switched
manually, as described above.
REAR LIGHT WITH BRAKE LIGHT FUNCTION
For the rear light with brake light function, the rear
light is equipped with a sensor that triggers a stop
signal during braking. The motion sensor triggers as
soon as the speed of the cyclist decreases by more
than 1.6 m per second.
SETTING THE HEADLIGHT
Set the headlight as shown in fig. AE. Ensure that the light beam is not too high since other
road users might otherwise be blinded by it.
AE
All manuals and user guides at all-guides.com
AD
1
1
1
LIGHTING
1
1
1
EN 27