MOTO GUZZI CALIFORNIA JACKAL Werkstatt-Handbuch Seite 203

A
B
C
D
E
F
G
H
Q
I
L
M
N
O
P
62
N
M
M
O
R
S
T
• Push the foot valve "M" out of the case "N" with the
shock absorber rod;
• Check the foot valve "M" and its O-ring "O"; if damaged,
replace them;
• Remove the shock absorber rod together with the
pumping unit from the case, after fully unscrewing the
lock nut at its end.
• Remove the clamping nut "P" of the calibration
P
assembly and remove all the components
Check and replace what necessary; reassemble
following the order in the picture.
- retainer "Q";
- plate pack "R";
- pin "S";
- piston "T";
- clamping nut "P".
N.B.
During the removal of the sealing assembly, take
note of the direction of the plate position "R"
IMPORTANT
The shock absorber rod can be locked in a vice,
but without the aid of any support it might get
crushed because it is internally hollow
W
HEEL PARTS