MOTO GUZZI CALIFORNIA JACKAL Werkstatt-Handbuch Seite 447

A
B
C
D
N
E
M
F
G
H
I
L
M
N
O
P
10
Reassembly
Before reassembly, check each component accurately,
as described in the chapter "Check and overhaul" of this
section.
A
Outer races of the cone bearings on the case
Use proper punch "A", code 17945160, to assemble the
cone bearings outer races on the case.
Case components
To reassemble, carry out the removal procedures in
reverse order, checking that the number of shim rings
between spacer and bearing and between bearing and
bevel sprocket is the same, if no part has been replaced.
If a part has been replaced, a new shimming is required.
Nut "N" locking shall be carried out with the locking tool
"M", code 12907100, and with a wrench with torque 18 ÷
20 Nm and Loctite. If the pinion is shimmed correctly, it
shall turn freely but without play.
Assembly of the needle bearing inner race on the
drilled shaft
Use the proper tool "B", code 17948460, to press the
needle bearing inner race on the drilled shaft.
Assembly of the needle bearing outer race on the
housing
Use the proper tool "C", code 17948660, to press the
needle bearing outer race on the housing.
B
Housing case
While assembling the case "O" on the transmission
housing, make sure that the lubrication holes marked with
an arrow on the housing and on the case are lined up.
Remember to place the O-ring "D" between the case and
the housing.
C
O
R T H
EAR RANSMISSION OUSING AND
D
S
HAFT