A
B
C
D
E
F
G
H
A
I
L
M
N
F
O
P
10
B
C
D
4
ACCELERATOR / STARTER CONTROL
A
CCELERATOR CONTROL
The accelerator control hand grip, in all steering positions,
must feature a free travel, measured on the outer edge
of the hand grip, of 1,5 ÷ 2 mm.
If it needs adjustment: move the special adjusters "A"
A
placed on the control itself.
Check, by pushing the control button, that the internal
cables slide smoothly: if there is interference or hard spots,
replace them.
M
AINTENANCE OF ACCELERATOR CABLES
•
Remove the right-hand device "B" by loosening the
two fastening screws "C";
•
Grease the end of the cables "D" and the pulley "E";
•
Close carefully the control while placing the cables
"D" in the pulley of the gas control mobile body "E"
•
Lock the right-hand device with the two fastening
screws "C".
N.B. The latest series of motorbikes model
C
ALIFORNIA
desmodromic gas control (double transmission)
from chassis number KD115984.
Disassembly
•
Remove the lids of the throttle bodies covers "F";
E
•
Remove the cables "D" from the drum "G" of the
accelerator on the throttle body;
•
Loosen the two screws "C" and pull out the accelerator
control together with the cables from the handlebar.
Reassembly:
•
Install the accelerator cables in the chassis in the same
position they were before being removed;
•
Place the accelerator control in the handlebar and
B
tighten the screws "C";
•
Connect the cables to the accelerator drum on the
throttle body.
:
EV old type (1997-2000) includes the
D
G
C
ONTROLS