MOTO GUZZI CALIFORNIA JACKAL Werkstatt-Handbuch Seite 195

TROUBLES – CAUSES - SOLUTIONS
A
The following paragraph lists some of the fork troubles, their causes and suggests the possible solution.
Always refer to this table before operating on the fork.
B
C
T
ROUBLES
Oil leakage form the seal ring
D
Oil leakage form the bottom
The fork is too soft in each oil
E
adjustment condition
The fork is too hard in each oil
adjustment condition
F
The fork does not react to the
different adjustment
G
H
I
L
M
N
O
P
54
C
AUSES
1. Seal ring is worn
2. The stranchion is rigid
3. The ring is dirty
1. The foot gasket is faulty
2. The foot screw is loose
1. Oil lever is low
2. Spring is faulty
3. Oil viscosity is too low
1. Oil level too high
2. Oil viscosity is too high
1. Plug pin is blocked
2. Oil is dirty
3. Shock absorber valves are clogged
S
OLUTIONS
1. Replace the seal ringt
2. Replace stanchion and ring
3. Clean or replace it
1. Replace the gasket
2. Tighten the screw
1. Top up the oil level
2. Replace the spring
3. Change oil viscosity
1. Restore oil level
2. Change oil viscosity
1. Remove plug and clean it
2. Clean and replace oil
3. Remove and clean
W
HEEL PARTS