Light Beam Adjustment; Preparation For Long Periods At Rest - MOTO GUZZI CALIFORNIA JACKAL Werkstatt-Handbuch

A
B
A
C
D
E
F
G
H
I
L
M
N
O
P
16
10 m
L
IGHT BEAM ADJUSTMENT
The headlight must always be aimed at the correct height,
for driving safety and in order not to cause troubles for
on-coming vehicles.
For vertical aiming it is necessary to:
• Loosen screw "A" working from both sides of the
headlight;
• Position the motorbike at about 10 m from a vertical
wall and make sure that the ground is flat;
• Manually move the headlight upwards or downwards
until reaching the height illustrated in the figure.
8 PREPARATION FOR LONG PERIODS AT
REST
Should the vehicle not be used for a long period of time
(eg. in the winter season) it is necessary to take the
following precautions;
• Throughly clean all the vehicle;
• Empty the tank and the fuel system. If left in the tank
for a long time, the fuel would evaporate leaving resi-
due and deposits;
• Remove the spark plugs and put a little SAE 30 oil
into the cylinders. Then make the engine shaft do some
revolutions and refit the spark plugs;
• Reduce the tire pressure by about 20%;
• Position the vehicle so that the wheels do not touch
the ground;
• Protect the unpainted parts with oil to prevent them
from rusting;
• Remove the battery and keep it in a dry place where
there is no danger of frost and where it is away from
direct contact with sunlight; check its charge condition
about every month;
• Cover the vehicle to protect it from dust but make sure
that air can circulate.
C U
ONTROL AND
M
SE OF THE ORBIKE