Maintenance Procedures; Engine Oil Replacement - MOTO GUZZI CALIFORNIA JACKAL Werkstatt-Handbuch

A
B
C
D
E
F
G
H
I
L
M
N
O
P
4
2
The various maintenance procedures are described
below.
E
NGINE OIL REPLACEMENT
A good engine oil has special qualities.
Only use highly detergent engine oil whose container
certifies that its quality corresponds to, or is higher than,
SE,SF or SG operating requirements.
V
ISCOSITY
The other viscosity levels indicated in the table can be
used if the average temperature of the motorbike's area
of use is within the range indicated on the table.
A
After the first 500/1500 km (300/1000 mi) and after about
10000 km (6000 mi), replace the oil.
Replacement should be carried out when the engine is
warm to allow the oil to drain more quickly and thoroughly.
To bring the engine up to the standard temperature, please
see section C, chapter 3 in this manual.
Position a suitable pan under the oil sump to collect the
used oil, then replace it following the below procedures:
•
•
•
•
•
B
•

MAINTENANCE PROCEDURES

Unscrew the oil filler cap with dipstick "A";
Unscrew the oil-draining plug "B";
Drain all the used oil in the sump;
Screw down the oil-draining plug once again and
tighten it to the torque prescribed in the table, section
B, chapter 4 of this manual;
Pour in the quantity of new engine oil indicated in
chapter 2, section B in this manual through the special
hole;
Refit the oil filler cap with dipstick in the special seat
and bring it flush.
S M
CHEDULED AINTENANCE