Quick Clamp - Prophete CITY Bedienungsanleitung

QUICK-CLAMP
• E nsure before starting your ride that all quick-clamps are closed with sufficient tensing
force. If the quick-clamps are not closed sufficiently, parts may come loose. Danger of
accident!
• T he lever of the quick-clamp must be completely flush and must not stand off! Wheel
DANGER
quick-clamps and frame quick-clamps always must point backwards for reasons of
safety (when viewed in the cycling direction).
Danger of accident!
• If the quick-clamp lever generally can be closed very easily or trusted when closed, the
pre-tension will not be sufficient. Adjust the quick-clamp then. Danger of accident!
W
2
1
A quick-clamp comprises of a lever
ter-screw or nut
1 3
Release the quick-clamp by flipping over the lever
is completely flush (fig. W). On the first half of the closing movement, the lever must move
relatively easily; on the second half, it must move much stiffer. If this is not the case, the
quick-clamp must be adjusted, since it does not have enough tension.
SETTING THE QUICK-CLAMP
1. Release the lever
2. Adjust the pre-tension with the hexagonal screw
wrench. For quick-clamps with knurled screw
ally. For quick-clamps with a hexagonal nut
3. Push the quick-clamp lever
entirely.
SET THE AXLE QUICK-CLAMP
1. Release the lever
clamp.
2. Set the pre-tension with the clamping nut
X).
3. Push the quick-clamp lever
The lever must be flush entirely.
2
3
(fig. W) that produces the clamping force and a coun-
2
(fig. W) that sets the pre-tension.
4 5
(fig. W) of the quick-clamp.
2
(fig. W) back again with enough force. The lever must be flush
2
(fig. X) of the axle quick-
1
(fig. X) back again.
1
OPEN
4
. To close,push the lever
2
(fig. W) with a 5/6 mm hexagonal socket
1
+ (fig. W), you can adjust the settings manu-
3 5
(fig. W), use an SW5 wrench for setting.
4
X
(fig.
2
1
QUICK-CLAMP
2
2
5
back until it
2
2
EN 17