Prophete CITY Bedienungsanleitung Seite 101

SHIMANO NEXUS INTER 8
SETTING THE GEAR SHIFT
1. Use the shifting lever to put in the 4th gear.
2. Check that the yellow marking lines on the holder and the
shifting wheel are aligned with each other
3. Turn the cable setting screw of the shifting lever
to align the yellow marking lines with each other.
4. Then return the shifting handle from the 4th to the 1st gear
and back to the 4th and check that the yellow marking lines
are still aligned with each other.
REMOVING THE REAR WHEEL
1. Use the shifting lever to put in the 1st gear.
2. Disconnect the brake cable
der to take out the wheel more easily later.*
3. Release the brake cable
to take out the wheel out of the drop-out more easily later.
4. Hold the rubber cover
from the cable sleeve holder part
BK).
5. Then remove the cable attached to the rubber bellows
from the slot of the holder
ber bellows (fig. BK).
6. Remove the cable attachment screw
wheel (fig. BL).
2
7. Release the axle nuts on both sides of the rear wheel with a
15 mm wrench.
8. Remove the axle nuts and the safety discs.
9. Now pull out the rear wheel from the drop-out.
(fig. BP).
1
(fig. BM) from its guide in or-
1
(fig. BM) from its guide in order
1
and pull the cable sleeve holder
3
of the shifting unit (fig.
1
, but without damaging the rub-
2
from the shifting
1
BH
(fig. BI),
1
BI
BJ
4
5
BK
BL
GEARSHIFT
1
1
1
2
3
4
5
1 2
EN 39