First Commissioning / Inspections Before Starting A Ride; Initial Operation - Prophete CITY Bedienungsanleitung

FIRST COMMISSIONING & INSPECTIONS BEFORE STARTING A RIDE
FIRST COMMISSIONING &
INSPECTIONS BEFORE STARTING A RIDE
• Check whether your bicycle is safe for operation before every ride. Remember that your
bicycle may have fallen over when you did not see it or that third parties may have ma-
nipulated it.
• Perform the following inspections before every ride and make any settings that are nec-
DANGER
essary. Non-observance may lead to damage to the bicycle or failure of important parts!
Danger of damage and accidents!
WARNING

INITIAL OPERATION

The bicycle was delivered in the pre-installed condition for shipping-technical reasons. This
means that not all parts and screws will be tightened ex works. Before initial commissioning,
you must tighten and may have to set the following components:
• Saddle clamp
• Headlights
• Handlebar, stem and any
handlebar attachments (such as brake grips,
bell, gearshift lever, rotary handle switch)
For more detailed information about setting and installation, see the following chapters of
the bicycle components.
BEFORE STARTING THE RIDE
Before every ride, you must check the following parts for function or tight fit:
• lighting
• brakes (incl. tightness of the hydraulic brake system)
• quick-clamp
• saddle
• handlebar
• pedals
• rims (check for wear and concentricity)
• tyres (check for damage and barometric pressure)
Additionally, you must comply with the intervals indicated in the maintenance plan for regular
inspection and repair and observe the care and maintenance instructions (see chapter Main-
tenance | Care).
EN 8
• Pedals
• Basket
• gearshift
• spokes
• bicycle bell
• deflection/damper