Prophete CITY Bedienungsanleitung Seite 73

SETTING THE INCLINATION
1. Loosen the clamp spindle screw
pending on the version installed.
2. Adjust the inclination angle of the handlebar.
3. Turn the handlebar attachments (e.g. brake lever) back to the starting position.
4. Tighten the clamp spindle screw
(s. chapter torque specifications).
STEM WITH ANGLE ADJUSTMENT
SETTING THE POSITION AND HEIGHT
• The stem must not be pulled out beyond the mark
sertion depth
ty if this is not observed!
DANGER
1. Loosen the clamp screw
socket wrench.
2. You can now set the handlebar position or the stem height.
Always observe the mark of the minimum insertion depth.
3. Tighten the clamp screw
torque specification (s. chapter torque specifications).
SET STEM ANGLE
1. Loosen the lateral clamp screw
gon socket wrench.
2. Now adjust the desired angle at the stem.
3. Then tighten the clamp screw
the torque specification (s. chapter torque specifications).
SET HANDLEBAR INCLINATION
1. First loosen the clamp block screw
bar attachment with a 4 or 5 mm hexagonal socket wrench.
2. Adjust the inclination angle of the handlebar.
3. Tighten the clamp block screw
Torque specifications).
4. Turn the handlebar attachments (e.g. brake lever) back to the
starting position if necessary.
(fig. C + D) with a 5 or 6 mm hexagon socket wrench, de-
2
(fig. C + D) again well according to the torque specification
2
(fig. F) must not be visible. Danger of damage and accidents! - No warran-
2
(fig. F) with a 6 mm hexagon
1
(fig. F) again according to the
1
(fig. F) with a 6 mm hexa-
3
(fig. F) again according to
3
(fig. G) of the handle-
1
(fig. G) again well (s. chapter
1
(fig. F)! The mark of the minimum in-
2
F
3
G
1
1
HANDLEBAR
1
2
1
1
EN 11