Prophete CITY Bedienungsanleitung Seite 105

teeth of the upper guide roller of the derailleur and the cassette teeth should be five to seven
millimetres.
SET THE FRONT DERAILLEUR
• If there are any grinding sounds at the front derailleur during the ride, check the set-
tings of the front derailleur at once. Otherwise, there may be damage to the chain and
the gearshift.
Danger of damage!
WARNING
1. The guide plate
3
2-3 millimetres above the teeth of the large blade and run in
parallel to the large chain ring (fig. BW & BX). Correct the po-
sition of the front derailleur if necessary.
2. Switch to the smallest chain ring and the largest pinion of
the rear derailleur to set the swivel range of the front derail-
leur.
3. Turn the screw L
1
guide plate without grinding (fig. BX).
4
4. Switch onto the largest chain ring and the smallest sprocket
of the rear derailleur.
5. Adjust the chain with the screw H
outer guide plate
3
REMOVING THE REAR WHEEL
1. Disconnect the brake cable
to take out the wheel more easily later.
2. Loosen the axle nuts on both sides of the rear wheel with an
15 mm wrench or release the lever of the quick tensioner
(depending on equipment).
3. Take off the axle nuts and the washers.
4. Pull out the rear wheel from the drop-out.
INSTALLING THE REAR WHEEL
1. Place the chain on the pinion.
2. Place the rear wheel into the drop-out. Ensure that the
wheel is placed straight in the holder.
3. Push the shifting protection bracket (if present) and the
washers onto the axle.
4. Attach the wheel with the axle nuts on both sides with a
(fig. BW) of the front derailleur must be
out until the chain runs past the inner
, so that it runs past the
2
without grinding (fig. BX).
(fig. BY) from its guide in order
1
GEARSHIFT
BW
1 2
BX
4
BY
1
EN 43
3
2