Diagnosis Module; Fig. 16: Diagnosis Module: Front Panel View - Bosch Rexroth PSI 6 Serie Betriebsanleitung

288 / 460 Bosch Rexroth AG
Information on this product
5.2.4.8

Diagnosis module

Effect of control keys
Automatic displays
Only in combination with PSI 6xCx.xxx.
Esc

Fig. 16: Diagnosis module: Front panel view

Functions:
• Display the timer status, type, time, Ethernet configuration
• Reset faults / warnings
• Activate Boot mode
• Trigger "Timer Reset" (timer will be rebooted)
• Test display.
If nothing is shown on the display except the backlight, or if the STA­
TUS LED (cf. page 278) is illuminated red, the following timer sta­
tuses may be present:
• No timer firmware available.
Remedy: Load firmware.
• Timer boot mode is active.
Remedy: Initiate "Load firmware" or wait until firmware load has
been completed.
Esc Return to previous display / level.
Y
(Up) Move up within a menu.
B
(Down) Move down within a menu.
Enter Acknowledge - or - call up the next display / level.
Y B
The and keys both have an autorepeat function. If these keys
are pressed down for more than one second, the autorepeat function
is activated.
INIT: the timer is currently booting
RUN: the timer is in "Ready" state (normal state)
RUN <w>: a warning is present.
<w> represents the warning code. An additional code de­
fined, if any, is visualized by an arrow to the right. The "En­
ter" key displays the additional code.
<f>: a fault is present.
<f> represents the fault number and additional code.
The fault must be eliminated and reset in order to return the
timer to "Ready" state.
PSI 6xxx |
8-digit display
B
Y
Enter
1070080028 / 08