Module "Optical Fiber Profinet; Fig. 14: "Optical Fiber Profinet" Module - Bosch Rexroth PSI 6 Serie Betriebsanleitung

286 / 460 Bosch Rexroth AG
Information on this product
5.2.4.6

Module "Optical fiber ProfiNet"

PSI 6xCx.xxx

Fig. 14: "Optical fiber ProfiNet" module

1 Screw for attachment of the module
2 X51: SC-RJ-optical fiber connection port 1
3 X52: SC-RJ-optical fiber connection port 2
4 / 6 LED „L/A x" for link/activity (port 2 or 1, respectively):
off:
green:
green, flashing:
5 LED„ms" for module status:
off:
green:
green, flashing once: diagnostic event detected
green, flashing twice: triggered by SW tool for module identification in the network
red:
red, flashing once:
red, flashing twice:
red, flashing 3 times: station name not defined
red, flashing 4 times: module error
7
LED „CS" for communication status (regarding ProfiNet controller):
off:
green:
green, flashing:
Features:
• Suitable for PSI 6xxx.xxx (slot for fieldbus module)
• Optical fiber ProfiNet withdrawable module
• ProfiNet interface according to IRT classification, conformity class C
• Integrated WEB server
• Simple IP configuration via "Anybus IP config" software
Function:
• Linking the timer I/O to the higher-level PLC or the robot
• and linking the timer to a programming terminal (BOS) via Ethernet.
PSI 6x00.xxx
ETH2
no connection to network
connection to network established
data transfer active
module not initialized
module is working normally
module error that can possibly be corrected by rebooting the timer
configuration error
IP address not defined
no connection to ProfiNet controller
connection to ProfiNet controller established
connection to ProfiNet controller established, ProfiNet controller is in stop mode
PSI 6xxx |
1
2
3
4
6
5
7
1070080028 / 08