Anybus Module "Cc Ethernet 100 Mbit; Fig. 10: Anybus Module "Cc Ethernet 100 Mbit" (1-Port Variant) - Bosch Rexroth PSI 6 Serie Betriebsanleitung

282 / 460 Bosch Rexroth AG
Information on this product
5.2.4.2

AnyBus module "CC Ethernet 100 Mbit"

Features:
• Suitable for PSI 6xCx.xxx (slot X7E1)
• Fast Ethernet (100 Mbit/s), full-duplex mode
• Available as 1-port or 2-port variant. 2-port variant with integrated
switch
• Integrated WEB server
• Simple IP configuration
Function:
• For the simultaneous connection of several timers to the host level
via Ethernet (e. g. connection BOS programming terminal).

Fig. 10: AnyBus module "CC Ethernet 100 Mbit" (1-port variant)

1 Fastening screws
2 NS LED: Network status.
Off:
Green
Green, flashing
Red
Red, flashing
3 Ethernet interface. RJ45 female connector
4 LINK LED: Connection status.
Off
Green
Green, flickering
5 MS LED: Module status.
Off
Green
Red
Red, flashing
For information on installation, refer to Section 13.2.1 from
page 416.
Use the "Anybus IPconfig" software for the configuration of the
Ethernet (installation file is included in the BOS software package,
refer to BOS data medium: directory path "Tools/Anybus").
PSI 6xxx |
1
ETH1
No power supply or no IP address
The module is active or in wait mode
Waiting for connection
Double IP address or fatal event
Module not active
No connection, no activity
Connection established
Data transmission active
No power supply
Normal function
Severe error or fatal event
Light error
1070080028 / 08
2
3
4
5