Electrical Connection - Bosch Rexroth PSI 6 Serie Betriebsanleitung

246 / 460 Bosch Rexroth AG
Safety instructions
2.6.4

Electrical connection

Dangerous electrical voltage
Possibility of cardiac arrhythmia, burns, shock!
The electrical connection may only be made by a skilled electri­
"
cian who observes the valid safety regulations, the mains voltage
and the maximum current consumption of the plant sections.
Use suitable, insulated tools for all electrical connection work.
"
" Use appropriate fuses for the mains system.
E.g. fuses or main switches with overcurrent tripping are required
as current-limiting protective elements.
Insufficient PE conductor system
Reduction of personal/plant safety!
" The product must be connected to the PE conductor system of the
plant correctly.
Make sure that the conductor cross-section of the PE conductor is
"
of sufficient size.
" The electrical continuity of the PE conductor system must be veri­
fied in accordance with EN 62135-1 and EN 60204-1.
Insufficient emergency–stop/emergency-halt facilities
Reduction of personal/plant safety!
" Emergency–stop/emergency-halt facilities must be active and wi­
thin reach in all system modes.
" Please note EN 62135-1 and EN 60204-1.
Releasing an emergency–stop/emergency-halt facility must not
"
result in an uncontrolled restart of the system.
" Make sure that moving system elements are halted safely before
accessing the danger area of the system!
" Check the proper functioning of the emergency-stop/emergency-
halt circuit prior to start-up.
PSI 6xxx |
WARNING
1070080028 / 08