Installation And Assembly - Bosch Rexroth PSI 6 Serie Betriebsanleitung

256 / 460 Bosch Rexroth AG
General information on damage to property and products
3.2

Installation and assembly

Improper handling of devices with water cooling
Leakage in the cooling circuit possible!
" Make sure that the water connections and hose bridges (hose
bridge: refer to fig. 63: page 358) are never pressed or squeezed
when lifting the device from the transport packaging or during
transport.
Never pull the hose bridge.
"
Metal burrs from drilling and sawing work
Possibility of short-circuits, damage to electrical equipment, unex­
pected plant reactions!
All affected components in the switch cabinet should be well parti­
"
tioned prior to all work!
Non-compliance will result in the extinction of any warranty
claims.
" Remove all metal burrs carefully after work.
Water leakage while connecting cooling water lines
Possibility of damage to the electrical equipment, unexpected
plant reactions!
" All affected components in the switch cabinet should be well parti­
tioned prior to all work!
Non-compliance will result in the extinction of any warranty
claims.
Remove residual moisture carefully after work.
"
Leakage in the cooling fluid circuit
Possibility of damage to the electrical equipment, unexpected
plant reactions!
Install the water-cooled modules so that the units inside the switch
"
cabinet are sufficiently protected against leaking cooling water.
Heat accumulation caused by insufficient clearance
Possibility of temporary interruption of the welding process, a re­
duced useful life of the product, destruction of the device, damage
to the electrical equipment, unexpected plant reactions!
" Make sure that an installation clearance of at least 100 mm re­
mains above and below the product.
PSI 6xxx |
NOTICE
1070080028 / 08