310 / 460
Bosch Rexroth AG
Information on this product
INTERBUS-S connection IN
(coming from previous IB-S node)
- For pin assignment, refer to page 311
Diagnostic messages of the module:
U
: Unit Supply; power supply available
S
- RC: Remote bus Check; bus link (coming from previous IB-S
node) exists.
- BA: Bus Active; data transmission is active
- RD: Remote Disable; indicates that the bus link (to the next IB-S
node) has been switched off.
- TR: Transmit/Receive; signals PCP communication
INTERBUS-S connection OUT
(going to the next IB-S node)
- For pin assignment, refer to page 311
Discrete inputs
- Voltage supply of the signal inputs (24 V
- Signal inputs I0 to I7 (24 V
Discrete outputs
- Voltage supply of the signal outputs (24 V
- Signal outputs O0 to O7 (24 V
Fig. 26: Front panel view: "E/A IBS X_FERN_8EA" I/O module
Cable type:
ID code:
, 0 V)
DC
)
DC
, 0 V)
DC
)
DC
PSI 6xxx |
copper cable, according to INTERBUS-S spe
cification
47 (dec.)
X13
X12
X15
X14
1070080028 / 08