Bosch Rexroth PSI 6 Serie Betriebsanleitung Seite 409

1070080028 / 08 | PSI 6xxx
Additional steps if the dismantled unit is to be replaced:
Install the new unit (refer to Section „Assembly" from page 341).
11.
Exit the BOS, if it is active.
12.
The procedure is described in the online help of the BOS (keyword
„Exiting BOS 6000").
Carry out a commissioning procedure (refer to page et seq. 387).
13.
If necessary after commissioning, enter the necessary data into the
14.
weld timer again.
In this context, please also note the information on the replacement
of a defective timer.
This information is provided in the online help of the BOS (keyword
„Replace defective WT").
Bosch Rexroth AG 409 / 460
Dismantling and replacement