Programming And Operation - Bosch Rexroth PSI 6 Serie Betriebsanleitung

1070080028 / 08 | PSI 6xxx
5.2.1

Programming and operation

All necessary parameters are always kept in a battery-buffered RAM in­
side the timer.
Operation, programming and diagnosis are performed via the connec­
ted PC. The following options are available for connecting the PC:
• V24 interface X1
(for the PSI 6x00.xxx types)
• V24 interface X3C or USB interface X3U
(for the PSI 6xCx.xxx types; can be used alternatively)
• optionally available field bus interface (e.g. Ethernet).
While the V24/USB connection is intended for accessing a single timer
only (e.g. local programming), the field bus interface provides for the si­
multaneous connection of several timers.
Conditions for programming and operation at the PC:
• PC with operating system Windows XP with Service Pack 3 or higher
• BOS software (Bedienoberfläche Schweissen = welding user inter­
face)
• V24/USB interface cable or corresponding installation for field bus
interface.
Via BOS both "online" and "offline" programming are possible.
• offline:
no active connection to timer possible.
Diagnosis or visualization are not possible.
Programming is carried out on the PC, where the program is stored
and can be transferred to the timer later.
• online:
requires active connection to timer.
Diagnosis and visualization are possible.
Programming is carried out on the PC. Each parameter is retrieved
from the timer and written back to the timer after confirmation. As a
result, any parameters that have been modified will take effect upon
the next program start of the systemat the latest.
For detailed information on the BOS software, please refer to the
BOS online help.
Bosch Rexroth AG 271 / 460
Information on this product