Stryker SDC3 Bedienungsanleitung Seite 36

C C o o m m - -
m m a a n n d d D D e e v v i i c c e e
M M e e n n u u S S u u b b - - M M e e n n u u
3 Up
Up
High
Low
Stop
Activate
Stop
CrossFire and CrossFire 2 with Connected Serfas Probe Voice Commands
These commands control a Serfas probe connected to a CrossFire or CrossFire 2 through
the Device Control menu on the surgical display.
C C o o m m m m a a n n d d
M M e e n n u u
Serfas
Visum LED Overhead Lights Shortcut Commands
You can speak these commands for the Visum LED Overhead Lights from any menu, once
the Device Control menu is active.
C C o o m m m m a a n n d d
OR Lights
Activate
Visum LED Overhead Lights and Camera Voice Commands
EN- 32
D D e e s s c c r r i i p p t t i i o o n n
Increases the speed by 900 rpm at an increment of 300 rpm
per up
Increases the speed by 300 rpm
Sets the handpiece speed to high range
Sets the handpiece speed to low range
Stops the handpiece motor
Starts the handpiece motor
Stops the handpiece motor
D D e e v v i i c c e e S S u u b b - -
M M e e n n u u
Forced
Modulation
Cut Up
Cut Down
Coag Up
Coag Down
D D e e s s c c r r i i p p t t i i o o n n
Turns the
overhead lights
on.
D D e e s s c c r r i i p p t t i i o o n n
Turns forced modulation on
Moves the Power Level up by 1 setting
Moves the Power Level down by 1 setting
Moves the Coagulate Power Level up by 1
setting
Moves the Coagulate Power Level down by 1
setting
C C o o m m m m a a n n d d
OR Lights Turn
Off
D D e e s s c c r r i i p p t t i i o o n n
Turns the overhead lights
off.