Wearing The Jabra Wireless Headset - Stryker SDC3 Bedienungsanleitung

1. VisionPro 26" LED Display - Connect the male connector end of the DB9 cable to the
Display.
N N o o t t e e : : I I f f t t h h e e D D i i s s p p l l a a y y i i s s i i n n s s t t a a l l l l e e d d i i n n a a n n I I n n t t e e g g r r a a t t e e d d S S u u i i t t e e , , a a D D B B 9 9 c c a a b b l l e e s s h h o o u u l l d d a a l l r r e e a a d d y y
b b e e c c o o n n n n e e c c t t e e d d . .
2. EDAM, DB9 Connector - Connect the other end of the DB9 cable to the EDAM adapter.
3. EDAM, USB Type B Connector - Connect the Type B end of the USB cable to the
EDAM adapter.
4. SDC3, USB Type A Connector - Connect the Type A end of the USB cable to one of the
Device ports on the SDC3.
• The EDAM LED shows solid green for approximately 15 seconds while the Display
connects to the SDC3.
• The connection is complete when the LED indicator light is blinking green.
3.7

Wearing the Jabra Wireless Headset

W W a a r r n n i i n n g g : : The surgeon must put on and properly position the headset prior to
scrubbing. Once scrubbed and sterile gowned, the surgeon must not touch the headset.
Doing so will breach the sterile field.
1. Put on the cap and mask.
2. Place the headset and adjust it so that the headphone is covering the ear, and the
headband is comfortable. This can be done by the surgeon or with assistance.
3. Position the microphone at the corner of the mouth.
4. Complete scrubbing as instructed by hospital policy. The surgeon must not touch the
headset after this point, as it is not sterile.
EN- 14
Example: A properly positioned headset