Stryker SDC3 Bedienungsanleitung Seite 29

C C o o m m m m a a n n d d
Pump Activate
Pump Wash
On
Pump Wash
Off
Pump Drain On
Pump Drain Off
Pump Clear Off
CrossFlow Pump Voice Commands
These commands control the pump through the Device Control menu on the surgical
display.
C C o o m m m m a a n n d d M M e e n n u u
Activate
Pressure
Flow
Wash
Drain
Clear
Vacuum
D D e e s s c c r r i i p p t t i i o o n n
Starts the pump.
Starts pump
wash mode.
Stops pump
wash mode.
Turns the pump
drain mode on.
Only available
when the
CrossFlow is not
activated.
Turns the pump
drain mode off.
Turns the pump
clear mode off.
D D e e v v i i c c e e S S u u b b - -
M M e e n n u u
—
Up
Down
Up
Down
Off
On
Off
On
Off
On
Off
C C o o m m m m a a n n d d
Pump Stop
Pump Vacuum
On
Pump Vacuum
Off
Pump Hot Swap
or
Pump Cannula
Swap
Pump Clear On
D D e e s s c c r r i i p p t t i i o o n n
The pump is activated by voice command
Increases the pump pressure by 5 mm Hg.
Decreases the pump pressure by 5 mm Hg.
Increases the flow by 0.25 l/min
Decreases the flow by 0.25 l/min
Turns the wash mode off
Turns the wash mode on and activates the
pump
Turns the drain mode off
Turns the drain mode on
Turns the clear mode off
Turns the clear mode on
Turns the vacuum mode off
D D e e s s c c r r i i p p t t i i o o n n
Stops the pump.
Turns the pump vacuum
mode on.
Turns the pump vacuum
mode off.
Lets you switch the cannula
through which the inflow
tubing is attached without
having to recalibrate the
pump.
Turns the pump clear mode
on.
EN- 25