Drive Function - Otto Bock C2000 Gebrauchsanweisung

Operation
INFORMATION
The parameter settings can be changed by the specialist
dealer in accordance with the user's desire in what speed
level or menu he / she wants the power wheelchair to be
after switching on.

6.3.3 Drive Function

CAUTION
Risk of injury due to uncontrolled operation of the power
wheelchair. Switch off the controls on the power wheel-
chair whenever you do not need them. This will prevent you
from unintentionally activating the joystick.
CAUTION
Risk of injury due to tipping during operation. Observe
the following safety information when operating the power
wheelchair:
n Short-term operation on inclines up to a maximum of
22 %.
n When driving downhill, reduce speed in accordance
with the degree of the incline.
n Do not cross differences in height of more than 140 mm.
144 Ottobock
|
n Do not cross steps or curbs without braking first.
n Driving backwards should be limited to manoeuvring
or short distances on level ground.
The power wheelchair has been approved for ascending or
descending inclines of up to 22 %. Navigating inclines
above this percentage value is not permitted.
To ensure safe downhill driving, the driving speed must be
reduced in accordance with the degree of incline (e. g. set it
to speed level 1).
The critical obstacle height of the power wheelchair is maxi-
mally 140 mm (depending on the load and driving direc-
tion). It is not permitted to cross obstacles higher than
140 mm. Obstacles such as steps or curbs must be crossed
at reduced speeds.
If there are obstacles in the travel path, it is important to
drive around them with a large margin of safety. On uneven
ground, the driving behaviour of the wheelchair may get out
of control. Therefore the speed must always be adapted to
the ground conditions.
The battery indicator and speed level are shown in the driv-
ing menu on the LCD display.
C2000