FORNO ELETTRICO PRESTIGE XL Gebrauchsanweisung Seite 76

TIMER ACTIVATION AND PROGRAMMING
It is possible to program two timers only with the electric
equipment switched on.
The functionality of two timers is completely identical. The
following notes will make reference to the Timer1 and the same
considerations can be applied to the Timer2. The indicating light
(LED) placed from the button side shows the activation
condition or not of the corresponding timer.
Timer activation:
1. To enter in Timer programming modality it occurs that the card is in "On" condition. If it isn't so it occurs to push the
"ON-OFF" button.
2. Push the button Timer "T1" and verify that the relative led switches on.
3. During the time that the button is pushed the seconds gauges (the dot that divides the hours from the minutes) remains
switched on and on the display, placed to the button side, the timer switching on timetable is visualized. To the button
releasing the inscription "On 1" will appear for about 2 seconds.
4. After a second pressure of the button the led switches off and to the consequent releasing the inscription "Off1" will
appear.
Timer programming:
1. Push the button "T1" for about 5 seconds: the timer display will begin to flash.
2. When the button is released only the numerals that identify the hours will flash. Working with the buttons "+" and "-" it
is possible to change their value. Pushing one f two buttons "+" or "-" the value is increased (or decreased) in automatic
way.
3. Pushing the button "T1" or "T2" it is possible to pass to the minutes regulation.
4. Similarly for what concern the hours, working on the buttons "+" and "-", it is possible to change the minutes value.
Pushing one of two buttons "+" or "-" the value is increased (or decreased) in automatic way.
5. Pushing the button "T1" or "T2" it is possible to come back to the hours regulation.
6. If for a period of four seconds none button "+", "-", "T1" or "T2" is pushed on the display timer the inscription "On 1"
(or "Off1" in function of the qualification condition or not of the timer) will appear for about 2 seconds and it will be
memorized as functioning parameter on the card.
Same method for the Timer2 through the button "T2".
Manuale Forni definitivo A5.doc
ORIGINAL INSTRUCTIONS TRANSLATION
Pag. di
30 30