FORNO ELETTRICO PRESTIGE XL Gebrauchsanweisung Seite 72

TIMER ACTIVATION AND PROGRAMMING
It is possible to program two timers only with the electric equipment switched on.
Timer 1
The functionality of two timers is completely identical. The following notes will make reference to the Timer1 and the same
considerations can be applied to the Timer2. The indicating light (LED) placed from the button side shows the activation
condition or less of the corresponding timer.
Timer activation:
1. To activate or disconnect a Timer it occurs that the card is in 'On" condition. If it isn't so it occurs to push the
"ON/OFF" button.
2. Push the button Timer 1 "T1" and verify the set timer value and after push a second time the button Timer1 "T1" and
verify that the relative led switches on.
3. At this point the Timer 1 is active.
4. Following to a second pressure of the button the led switches off and to the consequent release the Timer1 will be
disconnected.
Timer programming:
1. To enter in Timer programming modality it occurs that the card is in "On" condition.
2. If it isn't so it occurs to push the "ON/OFF" button.
3. Push the button Timer1 "T1" and verify the set timer value.
4. Push the button "T1" for about 5 seconds: the timer display will begin to flash.
5. When the button is released only the timer numerals will flash. Working with the buttons "+" and "-", it is possible to
change their value increasing the clock of 10 minutes in turn. Maintaining pushed one of two buttons "+" or "-", the
value is increased (or decreased) in automatic way.
6. After 5 seconds without the buttons pressure "+" and "-", you go out from the Timer1 modification modality and the
numerals will not flash more.
7. After some other second without the buttons pressure "+" and "-", the display will visualize again the current hour.
Same method for the Timer2 through the button "T2".
Manuale Forni definitivo A5.doc
ORIGINAL INSTRUCTIONS TRANSLATION
Timer 2
Pag. di
26 26