FORNO ELETTRICO PRESTIGE XL Gebrauchsanweisung Seite 71

ECONOMY OFF MODALITY:
The "economy off" modality is useful in the situations where it is necessary to reach quickly the temperature set for the desired
zone. In this situation, in fact, the resistance remains switched on in a constant way performing a minimum choking on the
power supplying.
ECONOMY ON MODALITY:
The "economy on" modality can be set every time isn't necessary to reach quickly the temperature set for the desired zone or
simply you wish maintain the reached target temperature. In this situation the power supplying on the heating resistance is
choked in a more or less marked way coherently with the pwm parameters set during the electric equipment calibration phase.
ERROR SITUATIONS:
If there is a mal functioning, this situation is highlighted on the displays through some error codes
Error Note
01 watch dog error
tc1 Temperature 1 surveying error – probe disconnected
tb Max. temperature error for the card
tF1 Max. temperature error for the gallery
tF2 Max. temperature error for the right bedplates
tF3 Max. temperature error for the left bedplates
For example if the temperature inside the gallery exceeds the agreed maximum value on the display the error code "tF1" will
be visualized.
In every case every time there is one of the error situations here above described it is advisable to contact immediately the
supplier.
FAN ACTIVATION:
The cooling fan switches on or switches off when the temperature measured on the electronic card rises or falls respectively
over or under the exact reference values set during the machine calibration.
CLOCK PROGRAMMING
It is possible to program the watch only with the electric equipment switched off
1. Pushing contemporarily the buttons "+" and "-", for some seconds the numerals included in the clock display will begin
to flash.
2. When both the buttons are released two numerals begin to flash that locate the hours. Working with the buttons "+" and
"-", it is possible to set the new timetable. In particular pushing one of two buttons "+" or "-", the numerals that
represent the current hour are increased or decreased in automatic way with step from 1 minute.
3. If for a time of about eight seconds none of two buttons is pushed the machine goes out from the "Programming Clock"
modality.
4. The timetable visualized on the display is set in the machine internal clock
Manuale Forni definitivo A5.doc
ORIGINAL INSTRUCTIONS TRANSLATION
Pag. di
25 25