FORNO ELETTRICO PRESTIGE XL Gebrauchsanweisung Seite 75

ECONOMY FUNCTION:
The energy conservation function is activated through the ECONOMY button and signalled from the illumination of the
corresponding gauge; this function is produced preventing the contemporary feeding of two resistances.
EMERGENCY CONFIGURATION
When the temperature inside the electric equipment exceeds the 500°C (signalled through the
visualization on the display of "Hit") or the electronic card temperature exceeds the 70°C (signalled
through the visualization on the display of "Hot") or there is the connection interruption with the
thermocouple temperature sensor (signalled through the visualization on the display of "HHH") the
control goes in an alarm condition signalled from the fixed illumination of the corresponding gauge; in
this case the electric equipment heating is deactivated. During the reopening of the operative normal
conditions, it occurs to work on the switching on button to come back to the normal functioning.
A NC bi metallic thermal switch connected in series to the remote control switches excitation coils that
feed the resistances supplies a further protection in case of the control mal functioning.
FAN ACTIVATION:
The electronic cooling fan, in normal conditions, is activated to the temperature of 40°C and deactivated at 30°C.
SETTING SAVING:
A non volatile memory contains the calibration and configuration data, in case of error in the data the control uses the
calibration preset data and takes shape for a set temperature of 327°C and an activated energy conservation modality. The error
situation in the calibration and configuration data is signalled through the visualization on the display of EEE during the
switching on.
CLOCK PROGRAMMING
It is possible to program the clock only with the electric equipment switched
off.
1. Push contemporarily the buttons Timer1 "T1" and Timer "T2".
2. When both the buttons are released two numerals start to flash that locate
the hours. Working with the buttons "+" and "-" it is possible to change the
clock hours value. Maintaining pushed one of two buttons "+" and "-" the
numerals are increased or decreased in automatic way.
3. Pushing the button "T1" or "T2" it is possible to pass to the minutes
management.
4. Similarly for what concern the hours, working on the buttons"+" and "-" it
is possible to change the minutes value. Maintaining pushed one of two
buttons "+" and "-" the numerals are increased or decreased in automatic
way.
5. Pushing the button "T1" or "T2" it is possible to come back to the hours
management.
6. If for a time of about eight seconds none of four buttons is pushed the
machine goes out from the "Clock Programming" modality.
7. The timetable visualized on the display is set in the machine internal clock
Manuale Forni definitivo A5.doc
ORIGINAL INSTRUCTIONS TRANSLATION
Pag. di
29 29