Electric Seat Height Adjustment - Otto Bock C1000 DS Gebrauchsanweisung

INFORMATION
When getting into or out of the power wheelchair, bring
the seat to a level position.

7.1.2 Electric Seat Height Adjustment

WARNING
Risk of falling due to improper use of the seat height
adjustment feature.
„ Drive in street traffic only with the seat height adjust-
ment lowered.
„ Use the seat height adjustment feature only with the
backrest in the upright position.
„ When driving with the seat height adjustment feature
raised, fasten the belts (lap belt, four-point belt) and
do not lean out beyond the seat surface.
„ Ensure that creep speed is activated when the seat
height adjustment function is used. If this is not the
case, contact a specialist dealer immediately. Only
use the power wheelchair with the seat height adjust-
ment in its lowest position until the fault is repaired.
C1000 DS
NOTICE
Damage due to lack of maintenance of the seat height
adjustment feature.
„ Inspect the seat height adjustment feature for visible
signs of damage at least 1 x per month and ensure all
screw connections are tight.
„ Check for correct tyre pressure.
NOTICE
Risk of transportation damage. Always lower the seat
height adjustment feature fully for loading or transporta-
tion.
INFORMATION
Please also observe the safety instructions in the section
„Electric Seat Functions" > „Safety Instructions for Use".
The power wheelchair can be equipped with an optional
electric seat height adjustment feature. The seat height ad-
justment feature raises the seat using a motor drive.
The electric seat height adjustment feature is available in
different versions:
Electric seat height adjustment up to 400 mm
Electric seat height adjustment up to 300 mm
Accessories
Ottobock 191
|