Otto Bock C1000 DS Gebrauchsanweisung Seite 190

Accessories
„ Use the seat height adjustment and the seat tilt only
on firm, level ground.
„ Note that the climbing ability of power wheelchairs
with electric seat height adjustment and seat tilt is
reduced. Driving on inclines and slopes is permitted
under ISO 7176-1 and 7176-2 with lowered seat
height adjustment and lowered seat tilt up to max 6°
(10 %).
WARNING
Risk of falling caused by overload. Note that the maxi-
mum permitted load of the power wheelchair may be re-
duced when using the options „Electric seat height adjust-
ment" and „Electric seat tilt" (see „Technical Data" sec-
tion).
WARNING
Risk of pinching or crushing in the electric seat adjust-
ment area.
„ Note that when electric seat options are used, inher-
ent pinch and shear points are located between the
seat frame and the power wheelchair frame.
„ Ensure that no body parts, such as hands or feet, are
in the danger area while electric seat options are used.
190 Ottobock
|
„ Ensure that no interfering objects, such as clothing or
other obstacles, are in the danger area while power
seat options are used.
WARNING
Risk of pinching or crushing when actuators are over-
loaded. Avoid overloading the actuators. Overloading
may cause the spindle nut to break, causing the seat to
sag or the backrest to flip back suddenly.
NOTICE
Damage due to improper use of the electric seat op-
tions.
„ When using electric seat options, note that the seat
function actuators are not designed for continuous
use, only for short-term use under limited loads (10 %
load, 90 % idle time).
„ Observe the following guidelines: At maximum load
capacity, 10 seconds of activation time must be fol-
lowed by approx. 90 seconds of idle time. The electric
seat functions are considered independently of the
driving function for this purpose.
„ Only activate the electric seat functions if no fault or
error is present.
C1000 DS