Headrest Mounting Adapter (Standard Seat, Contour Seat); Other Optional Add-On Components; Figure 50 Adapter For Headrest Installation Kit - Otto Bock C1000 DS Gebrauchsanweisung

Accessories
When the power wheelchair is equipped with a Recaro®
seat, it may be retrofitted with a four-way chest strap or
chest belt.
The four-way chest strap makes it possible to restrain the
patient in the power wheelchair. The lower strap should be
placed between the pelvic bone and thigh, and should not
be too tight. The belt buckle is positioned at the front of the
body, in the centre. The shoulder straps should be posi-
tioned evenly on both sides on the thorax, and should not be
too tight.
Applying the four-way chest strap / chest belt
1. To close the four-way chest strap, connect all parts of
the belt buckle. The belt buckle must snap in place
audibly.
2. Verify that the belt has locked by trying to pulling it
apart. The four-way chest strap / chest belt should not
be too tight on the body. Objects caught under the belt
can cause painful pressure sores.
Changing the belt length
To increase the length of the belt, turn the buckle by 90° and
pull. To reduce the length of the belt, pull the overhanging
belt end.
210 Ottobock
|
7.4.5 Headrest mounting adapter (standard seat, con-
tour seat)
The power wheelchair can be equipped with an optional
headrest. An adapter is available for the headrest installa-
tion kit.
Figure 50 Adapter for headrest installation kit

7.4.6 Other optional add-on components

Puncture-proof tyres: Solid rubber tyres
Seating shell interface: For the adaptation of special
seating shells. Control panel holders for seating shells
are also available.
C1000 DS