Changing Defective Lights; Front Lights On Splash Guard; Front Lights On The Side Panel; Figure 56 Front Lights - Otto Bock C1000 DS Gebrauchsanweisung

9.4

Changing defective lights

9.4.1 Front lights on splash guard

INFORMATION
The front lights may only be installed and removed by au-
thorised personnel.
INFORMATION
Only the complete front light can be replaced on each
side.

9.4.2 Front lights on the side panel

NOTICE
Damage to the lighting due to moisture penetration
During installation, ensure that the plates are seated
accurately in the housing.
Ensure that the screws are seated tightly against the
plate.
INFORMATION
Lamp housings and lamps can both be ordered from the
specialist dealer.
C1000 DS
Maintenance, cleaning and disinfection
If the power wheelchair is equipped with a standard XL seat
or contoured XL seat, the front lights are fastened to self-
contacting side panels.
Figure 56 Front lights
1 Recess (use the screwdriver at this point)
2 Front LED light
Replacing the front direction indicator bulb
1. Remove the fuse (see the section „Changing the fuse").
2. Insert a narrow screwdriver into the recess on the di-
rection indicator housing and tip the pane down (see
Fig. 56, item 1).
Ottobock 227
|