Getting Into And Out Of The Power Wheelchair; From/To The Side; Figure 15 Adjusting The Lower Leg Length - Otto Bock C1000 DS Gebrauchsanweisung

Operation
3. Retighten the screws.
INFORMATION
When making the adjustment, ensure that the footplate bar
(Figure 15, item b) slides at least 60 mm into the swivel
segment (Figure 15, item c). After completing the adjust-
ment, tighten the set screw with a torque of 8 Nm.
Figure 15 Adjusting the lower leg length
164 Ottobock
|
6.2

Getting into and out of the power wheelchair

CAUTION
Risk of injury if the power wheelchair starts rolling.
Switch off the control unit before getting into and out of the
power wheelchair. This will automatically engage the mo-
tor brake.
NOTICE
Risk of breaking the arm rests due to excessive strain.
Note that the arm rests are not capable of bearing full
body weight, and therefore must not be used for getting
into or out of the wheelchair.
The modular design of the power wheelchair and the ease
with which you can remove the side panels and footrests
make it easy to get into and out of the wheelchair from the
side or from the front.
Users can get into and out of the wheelchair using the best
method for each individual.

6.2.1 From/to the side

Getting into the wheelchair from the side requires the user to
remove the right or left side panel depending on the side where
C1000 DS