Driving Function - Otto Bock C1000 DS Gebrauchsanweisung

The control unit of the power wheelchair is switched on and
off by pressing the On/Off button (see Figure 18, item 5). If
the control unit is not used for a certain period of time, which
is adjustable, the wheelchair is switched off automatically. It
is also possible to switch off the power wheelchair with the
On/Off button while driving. In this case, the wheelchair
brakes immediately until it stops.
INFORMATION
Under the parameter settings, the specialist dealer can
establish the default speed level or menu for the power
wheelchair after it is turned on according to the wishes of
the user.

6.3.4 Driving function

CAUTION
Risk of injury due to uncontrolled operation of the
power wheelchair. Switch off the control unit on the
power wheelchair whenever you do not need the driving
function. This will prevent you from unintentionally activat-
ing the joystick.
C1000 DS
CAUTION
Risk of injury due to tipping during operation. Observe
the following safety information when operating the power
wheelchair:
Operation of the wheelchair is limited to inclines up to
a maximum of 9,5° (17 %).
When driving downhill, reduce speed in accordance
with the degree of the incline.
Do not cross obstacles higher than 100 mm.
Do not cross steps or curbs without reducing speed.
Driving backwards should be limited to manoeuvring
or short distances on level ground.
INFORMATION
The control unit of the power wheelchair switches to a
safe mode at elevated temperatures and after driving up-
hill for extended periods of time, limiting the performance
of the power wheelchair. However, the user is able to
drive the power wheelchair out of a hazardous situation
at any time. Once the excessive temperature has been
alleviated (this may take several minutes depending on
the ambient temperature), the power wheelchair is once
again fully functional.
Operation
Ottobock 169
|