Range; Controlling Additional Electrical Functions - Otto Bock C1000 DS Gebrauchsanweisung

Operation
Display symbol(s)
Table 2 Battery indicator on the control panel

6.3.6 Range

INFORMATION
Information about the range of the power wheelchair can
be found in the chapter ‚Technical Data'.
Note that the batteries reach their full capacity only after
20 – 30 charge cycles, and the power wheelchair can
achieve the stated range only then.
Please note that the specified range was determined un-
der defined conditions in accordance with ISO 7176-4. In
practice the range can be reduced by up to 50 %.
172 Ottobock
|
Information
Charging process with drive
stop
Battery is under voltage, with
warning symbol
Battery is over voltage, with
warning symbol
The following factors influence the range of a power wheel-
chair:
Battery capacity
Age of the batteries
Ambient temperature
Driving conditions (e.g. terrain profile, condition of sur-
face)
Charging method
Use of power options
Body weight of user

6.3.7 Controlling additional electrical functions

INFORMATION
For more information on the additional electrical functions,
please see Section 7.
Additional electrical functions, e.g. electric back angle ad-
justment and seat tilt, are accessed by pressing the "M"
button (approximately 2 seconds).
To change between the different functions, briefly press the
button „M" or move the joystick to the right. The function that
is currently selected is shown on the LCD monitor. The re-
spective function can be extended or retracted by moving
C1000 DS