Otto Bock C1000 DS Gebrauchsanweisung Seite 141

NOTICE
Risk of damage due to improper use of the seat adjust-
ment functions. The power wheelchair may be equipped
with seat height adjustment, back angle adjustment and
seat tilt functions. The following particularities must be ob-
served during operation:
The seat function actuators are not intended for con-
tinuous use but only for short-term limited operation
(10 % use, 90 % idle time). General recommendation:
At maximum load capacity, 10 seconds of operation
should be followed by 90 seconds of idle time. The
electric seat functions are considered independently of
the driving function for this purpose.
The maximum load capacity of the seat with seat
height adjustment function is 130 kg or 200 kg.
The seat height adjustment function may not be oper-
ated in case of errors or malfunctions.
If creep speed is not activated when the seat height
adjustment function is operated, please visit a special-
ist dealer immediately. The power wheelchair may only
be used with the seat in its lowest position until the
problem is corrected.
C1000 DS
NOTICE
Risk of damage due to excessive heat or cold. The
power wheelchair can only be operated in the temperature
range from -15 °C to +40 °C. It must not be operated at
temperatures outside this range.
NOTICE
Risk of damage due to overloading / excessive strain.
The maximum load capacity for the standard version of the
power wheelchair is 140 kg. It is possible to have the
power wheelchair retrofitted for a maximum load capacity
of 200 kg. If the power wheelchair is equipped with a seat
height adjustment unit, the maximum load capacity is
130 kg, optional 200 kg.
NOTICE
Damage to tyres due to excessive tyre pressure. Do not
exceed the tyre pressure specified in Section "Technical
Data".
Safety instructions
Ottobock 141
|