Herunterladen Inhalt Inhalt Diese Seite drucken

bürkert TopControl Basic 8696 Bedienungsanleitung Seite 33

Elektropneumatischer stellungsregler
Vorschau ausblenden Andere Handbücher für TopControl Basic 8696:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Type 8696
Installation
For version with plug-in hose connector, remove the collets (white nozzles) from both pilot air ports (if
present).
Figure 17:
Installing the switch spindle, series 2103, 2300 and 2301
noTe!
improper installation may damage the groove ring in the guide element.
The groove ring is already be pre-assembled in the guide element and must be "locked into position" in the
undercut.
▶ When installing the switch spindle, do not damage the groove ring.
Push the switch spindle through the guide element.
noTe!
screw locking paint may contaminate the groove ring.
▶ Do not apply any screw locking paint to the switch spindle.
To secure the switch spindle, apply some screw locking paint (Loctite 290) in the tapped bore of the spindle
extension in the actuator.
Check that the O-ring is correctly positioned.
Screw the guide element to the actuator cover (maximum torque: 5 Nm).
Screw switch spindle onto the spindle extension. To do this, there is a slot on the upper side
(maximum torque: 1 Nm).
Push puck onto the switch spindle and lock into position.
Puck
Switch spindle
Guide element
Groove ring
max. 1 Nm
max. 5 Nm
Actuator cover
O-ring
Spindle extension
english
33

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis