Atlas Copco MicroTorque G4 Produktanweisungen Seite 16

Product Instructions
Critical error
License invalid
License has expired 0x1D
Friction too high
16
Code Description
0x1C The license is in-
valid.
A trial license has
expired.
0x1E The friction mea-
sured during startup
calibration is higher
than the allowed
friction configured
in ToolsTalk.
© Atlas Copco Industrial Technique AB - 9836 620200 00
EN
Possible cause(s)
1) A new tool was
connected and acti-
vated but the license
wasn't updated for
that tool / controller
combination.
2) The EEPROM is
not working cor-
rectly.
This error code is
deprecated.
1) The tool is not
running freely dur-
ing startup calibra-
tion.
2) The mechanical
friction of the tool
has increased be-
yond acceptable lev-
els.
MicroTorque Controller G4
Solution(s)
1) Set a correct li-
cense code.
2) Replace con-
troller.
This error code is
deprecated.
1) Let the tool run
freely during con-
troller startup.
2) Replace the tool.