Atlas Copco MicroTorque G4 Produktanweisungen Seite 13

MicroTorque Controller G4
Torque not reached
Angle exceeded
Angle not reached
Depth exceeded
Depth not reached
Error messages
Critical error
Joint parameter error
pgm xx
Controllerparam. er-
ror
Tool parameter error 0x11
Code Description
0x00 This means that the
controller failed to
restore Pset xx from
the EEPROM and
that default values
for that Pset has
been loaded instead.
0x10 This means that the
controller failed to
restore controller pa-
rameters from the
EEPROM and that
default values has
been loaded instead.
This means that the
controller failed to
restore spindle (tool)
parameters from the
EEPROM and that
default values has
been loaded instead.
© Atlas Copco Industrial Technique AB - 9836 620200 00
EN
The defined Min. torque for the step has not been
reached.
The defined Max. Angle for the step has been ex-
ceeded.
The defined Min. Angle for the step has not been
reached.
The defined Max. Angle from depth signal for the
step has been exceeded.
The defined Max. Angle from depth signal for the
step has not been reached.
Possible cause(s)
1) The controller
software has been
updated and EEP-
ROM structure has
been altered in the
new version. (This is
normal behaviour
and not an error).
2) The EEPROM is
not working cor-
rectly.
1) The controller
software has been
updated and EEP-
ROM structure has
been altered in the
new version. (This is
normal behaviour
and not an error).
2) The EEPROM is
not working cor-
rectly.
1) The controller
software has been
updated and EEP-
ROM structure has
been altered in the
new version. (This is
normal behaviour
and not an error).
2) The EEPROM is
not working cor-
rectly.
Product Instructions
Solution(s)
1) Restore the EEP-
ROM contents from
the parameter file
that was saved prior
to upgrading the
software, i.e. reload
G04 file.
2) Replace the con-
troller.
1) Restore the EEP-
ROM contents from
the parameter file
that was saved prior
to upgrading the
software, i.e. reload
G04 file.
2) Replace the con-
troller.
1) Restore the EEP-
ROM contents from
the parameter file
that was saved prior
to upgrading the
software, i.e. reload
G04 file.
2) Replace the con-
troller.
13