Atlas Copco MicroTorque G4 Produktanweisungen Seite 12

Product Instructions
Description
If the screw counting and sequencing feature is dis-
abled, one of the available 64 programs can be di-
rectly selected by turning the jog dial and pressing it
when ready. To make this possible, program selection
via jog-dial must be enabled.
If the screw counting and sequencing feature is en-
abled, one of the available 8 product types can be di-
rectly selected by turning the jog dial and pressing it
when ready. To make this possible, product type se-
lection via jog-dial must be enabled.
Each product type is a complete sequence of joints
which must be prepared and defined for each product.
The program- or product type selection can be pass-
word protected. To enter the password, select the sta-
tus page and press the jog dial for 4 seconds.
Reference
Controller messages
The controller can show the following messages on the status lines with reverse
contrast:
Messages in line 1
OK
Disabled
Unscrew
Error in step n
Messages in line 2
Global time exceeded
Global time not reached
Time exceeded
Time not reached
Torque exceeded
12
EN
Display
Tightening completed successfully.
External signal inhibits driver operation.
Unscrew process active.
A process error in step n has occurred as described in
the following line.
The defined Max. process time for the entire tighten-
ing process has been exceeded.
The defined Min. process time for the entire tighten-
ing process has not been reached.
The defined Max. time for the step has been ex-
ceeded.
The defined Min. time for the step has not been
reached.
The defined Max. torque for the step has been ex-
ceeded.
© Atlas Copco Industrial Technique AB - 9836 620200 00
MicroTorque Controller G4