Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 147

4. Set the exact value that has been read off and
confirm with .
5. Place the electronic rim distance gauge in contact
with the inside of the flange.
6. Measure the distance, set the exact value that has
been read off and confirm with
1
Fig. 132: Measuring the distance
1 Electronic rim distance gauge
7. Move the electronic rim distance gauge to its rest
position.
i
The rest position is the position where the
electronic rim distance gauge is resting fully in its
mount.
8. Place the calibration plate included in the scope of
delivery against the flange's surface.
9. Lock the calibration plate by using a quick-clamping
ring and inserting a small cone or a clamping cap
(on the mechanical version).
!
Make sure the calibration plate is centered relative
to the flange shaft.
i
On the pneumatic version, the pedal must be
pressed upwards for locking.
10. Position the plate in the vertical 12-o'clock position.
Fig. 133: Attaching the calibration plate
1 Calibration plate
Beissbarth GmbH
.
12
1
6
Maintenance | MT ZERO 6 Touch | 147
11. Close the wheel cover and confirm with
12. Open the wheel cover, place it in its rest position
and confirm with
13. Remove the calibration plate.
14. Attach a motor vehicle's wheel that is in very good
condition, of intermediate size and on a steel rim
(e.g. width of 5.5", diameter of 14") to the flange.
15. Enter the information for rim distance, width and
diameter by hand.
16. Place the electronic rim distance gauge against the
rim flange.
Fig. 134: Placing the electronic rim distance gauge on the rim
17. Hold the electronic rim distance gauge against the
rim and confirm with
"
Calibration completed.
18. Close calibration by tapping the associated symbol.
.
.
.
|
1 695 600 965 2020-02-27
en