Beissbarth MT ZERO 6 Touch Betriebsanleitung Seite 108

en 108 | MT ZERO 6 Touch | Operation
7. Operation
The wheel balancing machine is equipped with a touch
screen with the following functions:
R
Displaying wheel balancing parameter information.
R
Direct interaction with the touch-sensitive screen to
enter commands for the machine and to access its
functions.
i
Use your fingers or accessories suitable and
certified for using such equipment.
The displays will vary depending on the working phase.
The following sections contain a detailed description of
the device's operation.
7.1 Start screen
After the MT ZERO 6 Touch has been switched on and
has started up, the start screen with the name of the
machine and the version of the software installed will
be shown.
Fig. 54: Start screen
Stand by for 60 seconds until the main screen is shown.
It can be used to open the balancing phases or to
change the machine settings.
1
2
Fig. 55: Main screen ("Home")
|
1 695 600 965 2020-02-27
Designation
1 Diagnostics
2 Automatic selection
of the balancing
program
3 Wheel recognition
and manual selection
of the balancing
program
4 Wheel balancing
7.2 Monitor display
The following is a display example.
1
2
Fig. 56: Display example
1 Status bar
2 Content area
Status bar description
Symbols
3
4
Description
Checking the operating condition
of the sensors and measuring
components
Selection of the balancing program
based on the positioning of the
electronic rim distance gauge on
the wheel
R Screen for showing and changing
the rim data detected
R Changing the balancing program
selected
Screen for measuring wheel
imbalance and attaching balance
weights
Description
Press to open the wheel balancing machine
menu.
Press to open the main screen ("Home").
Indicates the user logged in
Indicates the type of the selected vehicle
Indicates the current program
Beissbarth GmbH